Installing/removing flip back armrests – Invacare Wheelchair Pronto M61 User Manual

Page 38

SECTION 6—ARMS

Installing/Removing Flip Back Armrests

ƽ WARNING

Make sure the flip back armrest release and height adjustment levers are in the

locked position before using the wheelchair.

NOTE: For this procedure, refer to FIGURE 6.5 on page 38.

NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the
arm sockets.

Installing

1. Slide the flip back armrest into the arm sockets on the wheelchair frame.

2. Install the quick release pin through the rear arm socket and flip back armrest.

3. Lock flip back armrest by pressing flip back armrest release lever into the locked

(vertical) position.

4. Lift up on flip back armrest to make sure the armrest is locked in place.

5. Repeat STEPS 1‐4 for opposite flip back armrest.

Removing

1. Unlock flip back armrest by pulling flip back armrest release lever into the unlocked

(horizontal) position.

2. Remove the quick release pin that secures the flip back armrest to the wheelchair

frame.

3. Pull up on the flip back armrest and remove the armrest from the arm sockets.

4. Repeat STEPS 1‐3 for the opposite flip back armrest, if necessary.

FIGURE 6.5 Installing/Removing Flip Back Armrests

Flip Back Armrest

Rear Arm Socket

Quick Release Pin

Front Arm Socket

Seat Frame

Flip Back Armrest

Release Lever

Locked

(Vertical)

Unlocked

(Horizontal)