Removing a drive, Removing, Drive – IBM THINKCENTER 8189 User Manual
Page 50
The
following
list
describes
some
of
the
drives
that
you
can
install
in
each
bay
and
their
height
requirements:
Bay
1
and
Bay
3
-
Maximum
height:
25.8
mm
(1.0
in.)
Bay
2
-
Maximum
height:
43.0
mm
(1.7
in.)
Removing
a
drive
1.
Remove
the
cover.
See
2.
Pivot
the
drive-bay
latch
handle
toward
the
front
of
the
computer
and
then
pivot
the
drive-bay
cages
upward,
as
shown,
until
latched
in
the
upright
position.
3.
Disconnect
the
signal
cable
and
power
supply
cable
from
the
drive
being
replaced.
Note:
Take
note
of
the
location
of
any
cables
you
disconnect.
You
might
have
to
disconnect
cables
to
other
drives
to
gain
access
to
the
drive
you
are
removing.
4.
For
the
hard
disk
drive
and
the
CD
drive,
you
can
lift
the
tray
out
of
the
computer.
44
Hardware
Maintenance
Manual