Installing a drive, Installing, Drive – IBM THINKCENTER 8189 User Manual
Page 53
Installing
a
drive
1.
If
you
are
installing
a
parallel
drive,
make
sure
the
drive
is
set
correctly
as
either
a
master
or
a
slave
device.
Jumper
the
new
drive
the
same
as
the
drive
being
replaced.
Serial
ATA
hard
disk
drives
do
not
require
a
master/slave
jumper.
Refer
to
the
documentation
that
comes
with
your
drive
for
master/slave
jumper
information.
2.
Install
the
drive
into
the
bay
as
shown.
3.
Secure
the
new
drive
(if
necessary)
with
the
screws
that
were
removed.
4.
If
necessary,
place
the
drive-bay
cages
back
into
the
chassis.
5.
Continue
at
Chapter
6.
Replacing
FRUs
47
This manual is related to the following products: