InFocus IN5122 - Manual (Page 14)

12
• If DHCP is "On" in the projector, the network connection between
the projector and computer may not be successful since the IP address may
change. If you like to use My Connection, set DHCP "Off" in the projector.
• If no profile is assigned to My Connection, it cannot be used.
NOTE
Go to 1.8 Confirming the connection to your destination. (&30)
[Troubleshooting]
Select [My Connection] and click [Connect].
If you select My Connection, the computer
will be connected to the projector through
the network by using the profile that is pre-
assigned to My Connection. (&35)
When you select My Connection, the
computer immediately connects to the
projector.
1.4.2 Selecting My Connection
n A network connection could not be established.
Windows prevented network configuration
changes.
You may log in the Windows under User
authority.
Click [OK] to return to the screen to select
the network connection mode. (&10)
Consult your network administrator and log in again as an Administrator. After
that, please go to 1.3.2 Starting the “LiveViewer”. (&9)
1. Connection to the network
1.4 Selecting the network connection mode (continued)