Motorola LS4208 - Manual (Page 56)

5 - 2 Symbol LS4208 Product Reference Guide
Connecting a Keyboard Wedge Interface
Figure 5-1 Keyboard Wedge Connection with Y-cable
To connect the Keyboard Wedge interface Y-cable:
1. Turn off the host and unplug the keyboard connector.
2. Attach the modular connector of the Y-cable to the cable interface port on the scanner. (See Installing the
Interface Cable on page 1-3.)
3. Connect the round male DIN host connector of the Y-cable to the keyboard port on the host device.
4. Connect the round female DIN keyboard connector of the Y-cable to the keyboard connector.
5. If needed, attach the optional power supply to the connector in the middle of the Y-cable.
6. Ensure that all connections are secure.
7. Turn on the host system.
8. Select the Keyboard Wedge host type by scanning the appropriate bar code from Keyboard Wedge Host
Parameters on page 5-4.
9. To modify any other parameter options, scan the appropriate bar codes in this chapter.
Male DIN Connector
Female DIN Connector
Keyboard Connector
NOTE
Interface cables vary depending on configuration. The connectors illustrated in Figure 5-1
are examples only. The connectors may be different than those illustrated, but the steps to
connect the scanner remain the same.