Motorola LS4208 - Manual (Page 162)

12 - 14 Symbol LS4208 Product Reference Guide
UPC/EAN/JAN Supplemental Redundancy
With Autodiscriminate UPC/EAN/JAN Supplementals or one of the supplemental modes selected, this option
adjusts the number of times a symbol without supplementals is decoded before transmission. The range is from 2
to 22 times. Five or above is recommended when decoding a mix of UPC/EAN symbols with and without
supplementals, and the autodiscriminate option is selected. The default is set at 7.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes in Appendix D,
Numeric Bar Codes . Single digit numbers must have a leading zero. To correct an error or change a selection,
scan Cancel on page D-3 .
Transmit UPC-A Check Digit
The check digit is the last character of the symbol used to verify the integrity of the data. Scan the appropriate bar
code below to transmit the bar code data with or without the UPC-A check digit. It is always verified to guarantee
the integrity of the data.
UPC/EAN/JAN Supplemental Redundancy
*
Transmit UPC-A Check Digit
Do Not Transmit UPC-A Check Digit