Motorola LS4208 - Manual (Page 133)

Wand Emulation Interface 9 - 7
Convert All Bar Codes to Code 39
By default, the Wand Emulation interface sends data to the attached host in the same symbology that was
decoded. This can be a problem for customers with older systems that do not recognize newer symbologies (for
example, GS1 DataBar).
Enabling this parameter ignores the original symbology decoded, and outputs the data as if it were a Code 39 bar
code. Any lowercase characters in the original data stream are transmitted as uppercase characters. This also
allows ADF rules.
If Ignore Unknown Characters is enabled, any characters that do not have a corresponding character in the Code
39 symbology set are replaced by a space.
If Ignore Unknown Characters is disabled, if any characters that do not have a corresponding character are
encountered, the scanner emits an error beep and no data is transmitted.
NOTE
ADF Note: By default, the Wand Emulation interface does not allow scanned data to be
processed by ADF rules. Enabling this parameter has the side effect of allowing the scanned data
to be processed by the ADF rules (see
Chapter 14, Advanced Data Formatting ).
Enable Convert to Code 39 for Wand Host
*
Disable Convert to Code 39 for Wand Host