Motorola LS4208 - Manual (Page 215)

Chapter 13 Miscellaneous Scanner Options
Introduction
This chapter includes commonly used bar codes to customize how data is transmitted to the host device. Refer to
the Advanced Data Formatting Programming Guide p/n 72-69680-xx for further customization options.
The scanner ships with the settings shown in the Miscellaneous Scanner Options Default Table on page 13-2 (also
see
Appendix A, Standard Default Parameters for all host device and miscellaneous scanner defaults). If the
default values suit requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in non-volatile
memory and are preserved even when the scanner is powered down.
If not using a Synapse or USB cable, select a host type (see each host chapter for specific host information) after
the power-up beeps sound. This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, scan a default bar code in Default Parameters on page 4-3. Throughout the
programming bar code menus, default values are indicated with asterisks (
*
).
Scanning Sequence Examples
In most cases, scan one bar code to set a specific parameter value. Other parameters, such as Prefix Value,
require scanning several bar codes. See each parameter for descriptions of this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
*
Disable No Read
Feature/Option
* Indicates Default