Motorola LS4208 - Manual (Page 245)

Advanced Data Formatting 14 - 23
Setup Field(s)
Table 14-1 Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor to a Character
Scan the Move Cursor To Character bar code
on page 14-24, then any printable ASCII
character from the
Alphanumeric Keyboard .
When this is used, the cursor moves to the
position after the matching character. If the
character is not there, the rule fails and ADF
tries the next rule.
14-24
Move Cursor to Start of Data
Scan this bar code to move cursor to the
beginning of the data. 14-24
Move Cursor Past a Character
This parameter moves the cursor past all
sequential occurrences of a selected character.
For example, if the selected character is ‘A,’
then the cursor moves past ‘A,’ ‘AA,’ ‘AAA,’ etc.
Scan the
Move Cursor Past Character bar code
on page 14-24, then select a character from the
Alphanumeric Keyboard . If the character is not
there, the cursor does not move (i.e., has no
effect).
14-24
Skip Ahead “N” Characters Scan one of these bar codes to select the
desired number of positions to move the cursor
ahead. 14-25
Skip Back “N” Characters Scan one of these bar codes to select the
desired number of positions to move the cursor
back. 14-27
Send Preset Value Send prefix and/or suffix value by scanning the
appropriate bar code. These values must be set
using the Scan Prefix and Scan Suffix bar codes
on
page 13-4 .
14-28