Madrigal Imaging MP-8 - Manual (Page 78)

interpolating between “the two closest” setup memories. This feature is very
useful when adding a new source to the system and/or when much adjust-
ment is required. By using the “ASI with Save” feature, the projector can do
most of the required adjustments for you.
To perform an “ASI with Save”, press from the
Source Setup menu. A dialog box is displayed.
Press
to move the cursor bar to “Do It” then
press . New display settings will immediately be
calculated and saved in the current setup memory.
The only exception is when the current setup
memory is locked. If locked, display settings will not be modified. If
“Cancel” is selected from the dialog box, the operation is stopped. For
more information about the ASI logic process, refer to Appendix C,
ASR/ASI Logic Diagrams.
Notes about the ASI feature ...
ASI works better when there are many setup memories in the system.
For example, if you always use the same input and you never use Recall
memories (thus only one setup memory has ever been created), ASI will
not be effective. However, if many Input and Recall memories have been
used and adjusted for a variety of sources, the projector has more “knowl-
edge” in its database for performing an ASI. As this “knowledge” increases,
ASI accuracy improves.
Current Setup (Locked/Unlocked)
This utility allows you to lock or unlock the current setup memory. Locking
a setup memory prevents changes to display settings from being saved in
that memory. For example, if a locked Recall memory is selected and then
brightness is adjusted, the new brightness setting is only temporary. If the
Recall memory is reselected, the original brightness setting will be restored.
Note: When a locked setup memory is selected, a key icon ( ) is displayed
in the Source Message.
To lock or unlock the current setup memory, press from the Source Setup
menu. Item 3 in the menu indicates the current setting.
ASR (On/Off)
The ASR (Automatic Source Recall) feature provides automatic Recall
memory selection or ASI (Automatic Source Interpolation) for inputs
which have ASR set to On.
To turn ASR on or off for the current input, press from the Source
Setup menu. Item 4 in the menu indicates the current setting.
4
4 1 UTIL
3
3 1 UTIL
ENTER
2
OPERATION
3.36