Madrigal Imaging MP-8 - Manual (Page 14)

Figure 2-5. Screen Locations for Maximum Audience Coverage
2.3 Hardware
Setup
This section explains: how to convert the keypad from a built-in keypad to
a remote keypad, how to change keypad protocol and backlit settings, and
how to determine if reverse scan setup is required.
Keypad
➤
Conversion
The projector includes a multi-use full-function keypad which may be
configured for use as a built-in, IR remote, or wired remote keypad. The
keypad is configured at the factory for built-in use. It is located below the
front top cover. You can use the keypad as it is or re-configure it for
remote operation. You can also “hard wire” the keypad to be a protocol A
or protocol B keypad (see section 3.7, Utility Features for information
about keypad protocols).
Prime Audience
Area
Corner placement of screen
yields best audience coverage.
SQUARE ROOMS
Screen placement along short
wall yields best audience coverage.
RECTANGULAR ROOMS
Prime Audience
Area
INSTALLATION & SETUP
2.8