Madrigal Imaging MP-8 - Manual (Page 58)

To select or create a Recall memory:
Press .
where: m = the 1 st digit of the Recall memory number
n = the 2 nd digit of the Recall memory number
For example, to select Recall memory 01, press . Recall memory
01 will then be the current setup memory and its settings will be used for
the currently selected source. If this is the first time that the Recall memory
number is used, a new Recall memory is created. Any display adjustments
you make will be stored in the Recall memory.
Memory
➤
Allocation
Each time a setup memory is selected the projector checks its memory bank
to see if the selected memory exists. If it does exist, it uses the memory and
its display settings. If it does not exist, a small portion of memory is allocat-
ed for the new setup. Space is available for up to 75 setup memories. When
the last space is used up, a warning message is displayed. If this happens, call
for servicing to delete memories which you no longer use to make room for
new memories.
Locking Setup
➤
Memories
Setup memories may be locked or unlocked. Locking a setup memory pre-
vents adjustments to display settings from being saved in that memory. For
example, if Recall memory 08 is locked and selected, then brightness is
adjusted, the new brightness setting is only temporary. If the setup memory
is then reselected, the original brightness setting will be restored.
Note: When a locked setup memory is selected, a key icon ( ) is displayed
in the Source Message.
To lock or unlock the current setup memory, select option 3 from the
Source Setup menu (
). Option 3 indicates the current setting.
3.5 Display
Adjustments
This section describes the projector’s display adjustment functions. To access
all display functions, a full function keypad is required. If you are using the
IRIQ, only the primary display functions are available. There are four types of
display adjustment functions: Primary, Picture, Geometry, and Convergence.
• Primary Display functions include Brightness, Contrast, Detail, Color
and Tint. These functions are accessed directly from the keypad.
• Picture functions are used to adjust display settings that affect the projected
image. These functions include Position, Size, White Balance, Focus, Sync,
Blanking, Clamping, Retrace, and Decoding. Picture functions are accessed
via the Picture menu which is selected by pressing
on the keypad.
PIC
3 1 UTIL
1 0 RECALL
n m RECALL
OPERATION
3.16