Madrigal Imaging MP-8 - Manual (Page 123)

Appendix C
ASR/ASI Logic Diagrams
Check the
Input memory of the
currently selected input for
matching H & V scan
frequencies.
match
yes yes
no match
Change the current
setup memory to the
matched Input memory.
no
Do nothing.
A change in scan frequency is detected.
The change is greater than 100 Hz horizontal
or greater than 1 Hz vertical.
Is ASR
set to On for the
currently selected
input?
no
Switch to the selected
source and/or setup
memory.
A source, Recall memory, or channel was manually
selected. The H & V scan frequencies of the source
do not match that of the selected setup memory.
Is ASR
set to On for the
selected
input?
Search for a
Recall memory with
matching H & V scan
frequencies.
match match no match
ASI
Logic
Begins
Change the current
setup memory to the
matched Recall memory.
Search for an
Input memory with
matching H & V scan
frequencies.
match match no match
Use the display settings
of the matched Input
memory but do not update
the current setup memory.
Create new display set-
tings by interpolating the
two closest setup mem-
ories (in freq.). Do not
update the setup memory.
ASI
Functions
Adjustments made at
this point are stored
in the current
setup memory.
Adjustments made at this
point are displayed but
NOT stored in the current
setup memory.
ASR Logic Diagram
B.3