Madrigal Imaging MP-8 - Manual (Page 34)

Step 10
➤
Adjust C linearity as follows:
Press or until the horizontal line through the center of the crosshatch
is equally distant from the lines at the very top and bottom.
Press or until the center of the crosshatch is equally distant from the
vertical lines at the left and right edges.
Step 11
➤
Adjust S linearity as follows:
Press or until the height of each crosshatch square is equal from the top
to the bottom.
Press or until the width of each crosshatch square is equal from the left
to the right.
The source connected to the currently selected input should now be visible.
If there is no picture, check to see if the source is active.
Step 12
➤
Press , , or to adjust phase until the picture is centered on
the screen.
Step 13
➤
Press , , or to adjust the size of the picture. Ensure that objects in
your picture have the correct shape. For example, if there is a circle in your
picture, size should be adjusted until the circle is round, not oval.
Before After
Before After
Before After
Before After
INSTALLATION & SETUP
2.28