Removing the interface cable, Connecting power (if required) – Motorola LS1203 User Manual
Page 19
Getting Started
1 - 3
Removing the Interface Cable
To remove the interface cable:
1.
Unplug the installed cable modular connector by depressing the connector clip with the tip of a screwdriver, or
a paper clip as shown in
Figure 1-3
Removing the Interface Cable
2.
Carefully slide out the cable.
3.
Follow the steps for
Installing the Interface Cable on page 1-2
to connect a new cable.
Connecting Power (if required)
If the host does not provide power to the scanner, an external power connection to the scanner is required. To
connect power:
1.
Connect the interface cable to the bottom of the scanner, as described in
Installing the Interface Cable on page
2.
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
3.
Plug the power supply into the power jack on the interface cable. Plug the other end of the power supply into
an AC outlet.
NOTE
Different cables are required for different hosts. The connectors illustrated in each host chapter are
examples only. Actual connectors may be different than those illustrated, but the steps to connect the
scanner remain the same.