Decode upc/ean/jan supplementals, Decode upc/ean/jan supplementals -8 – Motorola LS1203 User Manual
Page 120
8 - 8
Symbol LS1203 Product Reference Guide
Decode UPC/EAN/JAN Supplementals
Supplementals are bar codes appended according to specific format conventions (e.g., UPC A+2, UPC E+2, EAN
13+2). The following options are available:
•
If you select Ignore UPC/EAN with Supplementals, and the scanner is presented with a UPC/EAN
plus supplemental symbol, the scanner decodes UPC/EAN and ignores the supplemental characters.
•
If you select Decode UPC/EAN with Supplementals, the scanner only decodes UPC/EAN symbols with
supplemental characters, and ignores symbols without supplementals.
•
If you select Autodiscriminate UPC/EAN Supplementals, the scanner decodes UPC/EAN symbols with
supplemental characters immediately. If the symbol does not have a supplemental, the scanner must
decode the bar code the number of times set via
UPC/EAN/JAN Supplemental Redundancy on page 8-11
before transmitting its data to confirm that there is no supplemental.
•
If you select one of the following Supplemental Mode options, the scanner immediately transmits EAN-13
bar codes starting with that prefix that have supplemental characters. If the symbol does not have a
supplemental, the scanner must decode the bar code the number of times set via
Supplemental Redundancy on page 8-11
before transmitting its data to confirm that there is no
supplemental. The scanner transmits UPC/EAN bar codes that do not have that prefix immediately.
•
Enable 378/379 Supplemental Mode
•
Enable 978/979 Supplemental Mode
•
Enable 977 Supplemental Mode
•
Enable 414/419/434/439 Supplemental Mode
•
Enable 491 Supplemental Mode
•
Enable Smart Supplemental Mode - applies to EAN-13 bar codes starting with any prefix listed
previously.
•
Supplemental User-Programmable Type 1 - applies to EAN-13 bar codes starting with a 3-digit
user-defined prefix.
User-Programmable Supplementals on page 8-11
.
•
Supplemental User-Programmable Type 1 and 2 - applies to EAN-13 bar codes starting with either of
two 3-digit user-defined prefixes. Set the 3-digit prefixes using
User-Programmable Supplementals on
•
Smart Supplemental Plus User-Programmable 1 - applies to EAN-13 bar codes starting with any
prefix listed previously or the user-defined prefix set using
User-Programmable Supplementals on page
•
Smart Supplemental Plus User-Programmable 1 and 2 - applies to EAN-13 bar codes starting with
any prefix listed previously or one of the two user-defined prefixes set using
.
NOTE
If you select 978/979 Supplemental Mode and are scanning Bookland EAN bar codes, see
Enable/Disable Bookland EAN on page 8-7
to enable Bookland EAN, and select a format using
.
NOTE
To minimize the risk of invalid data transmission, select either to decode or ignore supplemental
characters.