Minuteman UPS SNMP-32 Series - Manual (Page 38)

38
10. Troubleshooting
Problem: The NMS cannot ping the SNMP-32 card.
Solution: Make sure the network connection to the SNMP-32 card is good.
Solution: Make sure the cable is in good condition.
Solution: Make sure to set the Community String. Name the community with any lowercase name. A UPS
monitors a designated community.
Solution: Make sure to set the Manager Table.
Solution: Make sure the Gateway is correct.
Solution: Make sure to Save after the Setup Procedure.
Problem: The internal SNMP-32 card will not communicate and the LEDs are not illuminated.
Solution: Make sure the UPS is turned ON.
Solution: Make sure this is not a scheduled shutdown.
Problem:
The external SNMP-32 card will not communicate and the LEDs are not illuminated.
Solution: Make sure the UPS is turned ON.
Solution: Make sure that the external power adaptor is plugged into the UPS.
Solution: The power adaptor could be bad. Contact Tech Support.
Solution: Make sure this is not a scheduled shutdown.
Problem:
The SNMP-32 card will not communicate and all of the LEDs are ON.
Solution: There has been a collision of the packets. The SNMP-32 card needs to be reset. Press the reset button
on the SNMP-32 card for ten seconds and then release the reset button.
Problem:
The user cannot change from one Web Page to the next.
Solution: There has been a collision of the packets. The SNMP-32 card needs to be reset. Press the reset button
on the SNMP-32 card for ten seconds and then release the reset button.
Problem:
I forgot my Supervisor’s name/password.
Solution: The SNMP-32 card will need to be returned for repair. Contact Tech Support.