Minuteman UPS SNMP-32 Series - Manual (Page 25)

25
3. UPS Control
This screen is to provide remote UPS test functions (Fig. 35). Choose the test item and click on 'Apply' to
execute the test.
Quick Battery Test
The Quick Battery Test function will test the battery for 5-seconds.
General System Test
The General System Test function will test the UPS and the battery for-15 seconds. This test can only be
performed when the battery is fully charged.
Deep Battery Calibration
The Deep Battery Calibration function will test the UPS and the Battery until Low Battery Warning (LBW). When
this test is performed, the UPS will switch to the battery mode and operate until the Low Battery Warning alarm
occurs. Then the UPS will switch back to the normal AC mode.
Cancel Test
The Cancel Test function is to abort a test while the test is in progress.
Shutdown UPS (Battery mode only)
Selecting 'Shutdown UPS' will turn off the UPS. This function can only be performed in the battery mode. The
UPS will automatically restart when AC returns.
Put UPS in Sleep mode for XX minutes
When the UPS is in the Sleep mode, it will not provide power to the outlets. The UPS will restart once the Sleep
mode function is complete.
Cancel Shutdown
The Cancel Shutdown function is to abort a shutdown while a shutdown is in progress.
Audible alarm
• Disabled: Turn off the audible alarm.
• Enabled: Turn on the audible alarm.
• Muted: Mute the audible alarm until an event occurs (Fault, LBW).
• Disabled Until Low Battery Warning: Turn off the audible until a Low Battery Warning occurs.
Fig. 35-UPS Control Screen