Minuteman UPS SNMP-32 Series - Manual (Page 11)

11
4-2. Information: System Status
This screen shows the SNMP-32 card’s System Information and Network setting (Fig. 12). The information shown is
provided by SNMP-32 card or it is the user settings from the SNMP Utility Configuration pages.
1. System Information:
This section shows the System Information. The Firmware Version, the Serial Number and the System Time are
provided by SNMP-32 card. The other information is the user settings from the SNMP Utility Configuration
pages.
2. Network Status:
This section shows the Network settings. The MAC address is provided by SNMP-32 card. The other
information is the user settings from the SNMP Utility Configuration pages.
Fig. 12-System Status Screen
4-3. Configuration: Network
This screen is to set the Network settings (Fig. 13).
NOTE: SNMP-32 card will reboot after making changes to any of the following sections.
1. IP Address:
This section is to set the IP address.
2. Subnet Mask:
This section is to set the Subnet Mask.
3. Gateway:
This section is to set the Gateway.
4. Obtain an IP address:
This section is to choose to set the IP address manually or via DHCP.
NOTE: The four sections above can be set in either the SNMP Utility or the SNMP-32 card’s Web pages.
5. Primary DNS Server IP:
This section is to set the Primary DNS Server IP address.