Multitech MT1432BA - Manual (Page 151)

151
Appendix H - V.25bis Operation
Listing Delayed Phone Numbers (RLD) Command
When a phone number is dialed by a CRN command and a connection is not made, the number is
entered in the modem's V.25bis Delayed Number list along with the number of retry attempts. Any
further dialing attempts will be delayed some amount of time (determined by the regulations of each
country). While the delay is in progress, the modem will give a DLC indication. The list contains eight
numbers. When filled, the next number failing “bumps” off the oldest number on the list onto the
Forbidden Number list. Numbers on the Delayed Number list that succeed in a connect attempt are
removed. If a certain number of failed attempts occur (the number of failed attempts is specified by
each country), the number is entered into the V.25bis Forbidden Phone Number List. Forbidden
phone numbers cannot be dialed at all. To list the phone numbers on the V.25bis Delayed Phone
Number List, enter RLD and hit RETURN.
Listing Forbidden Phone Number (RLF) Command
Those phone numbers that have failed to connect the required number of times as specified by
country regulations are removed from the Delayed Number list and entered onto the V.25bis
Forbidden Number list. Numbers on the Forbidden Number list cannot be dialed at all for some
maximum amount of time, which is also specified by country regulations. In some countries, the time
might be one hour, and in others the number may never be dialed again. The forbidden list is eight
numbers long, with the newest number replacing the oldest if the memory is full. To list the numbers
in the Forbidden list enter RLF and hit RETURN.
Disregard or Connect to Incoming Calls (DIC or CIC) Command
The Disregard or Connect to Incoming Calls commands are used for Auto-Answer operations.
Depending on the country regulations, your modem will wait some amount of time or number of rings
before answering the call. During that time, you can stop the modem from answering the call by
entering the DIC (Disregard Incoming Calls) command. The CIC (Connect to Incoming Calls)
command will cause your modem to answer the call (either reversing the effect of a DIC command or
simply have your modem answer the call immediately without waiting the regulation time before
answering).
DTR Dialing ($D) Command
DTR Dialing is an alternate method of causing the modem to automatically dial a number. Data
Terminal Ready (DTR) is a signal that comes into the modem from the terminal or computer to which
it is connected via pin 20 of the RS-232 interface. In DTR Dialing, the modem will automatically dial a
stored number as soon as it receives a high DTR signal. The DTR Dialing method is popular when
using the modem in synchronous applications.
To enable DTR Dialing, enter the command AT$D1 and hit Return. The modem will now dial the
phone number you have stored as N0 when it receives a high DTR signal (see the D...N command in
Chapter 5).
DTR must remain high for the duration of the call, until disconnect. To disable DTR Dialing, enter the
command AT$D0 (or AT$D) and hit RETURN.
When you use DTR Dialing, be sure that DIP-Switch #1 is in the UP position, so that DTR is not
forced on.
In addition, when using DTR Dialing in a synchronous application, be sure that DIP-Switch #8 is in
the UP position to disable V.25bis Command mode.