Multitech MT1432BA - Manual (Page 145)

145
Appendix G - Result Code Summary
Appendix G - Result Code Summary
TERSE (Digit) VERBOSE (Words) Effect
0 OK Command was executed without error; ready for
next command.
1 CONNECT Modem has detected carrier and gone on-line.
2 RING Modem has detected ring caused by incoming call.
3 NO CARRIER No carrier signal has been detected within allowed
time.
4 ERROR Error in Command line (too many, or invalid
characters).
5 CONNECT 1200 Modem has detected carrier at 1200 bps and gone
on-line.
6 NO DIAL TONE No dial tone has been detected.
7 BUSY A busy signal has been detected.
8 NO ANSWER Remote system did not answer.
9 CONNECT 2400 Modem has detected carrier at 2400 bps and gone
on-line.
11 CONNECT 4800 Modem has detected carrier at 4800 bps and gone
on-line.
12 CONNECT 9600 Modem has detected carrier at 9600 bps and gone
on-line.
13** CONNECT 14400 Modem has detected carrier at 14400 bps and gone
on-line.
19* CONNECT 19200 Modem has detected carrier at 19200 bps and gone
on-line.
21* CONNECT 21600 Modem has detected carrier at 21600 bps and gone
on-line.
23 CONNECT 1275 Modem is connected in V.23 mode.
24* CONNECT 24000 Modem has detected carrier at 24000 bps and gone
on-line.
26* CONNECT 26400 Modem has detected carrier at 26400 bps and gone
on-line.
28* CONNECT 28800 Modem has detected carrier at 28800 bps and gone
on-line.
31* CONNECT 31200 Modem has detected carrier at 31200 bps and
gone on-line.
33* CONNECT 33600 Modem has detected carrier at 33600 bps and
gone on-line.
* 2834 Series only
** 1432 and 2834 Series only