Madrigal Imaging MP-9 - Manual (Page 87)

Figure 3-8. Independent IR Keypad Control
Caution: The keypad you are using may become inoperative if its protocol does
not match its setting in the menu.
Remote Jack
This setting determines how the projector responds to devices connected to
the REMOTE jack on the projector’s rear panel. This jack can accept input
from a wired keypad or remote IR sensor. Four settings are available: A or B,
A, B, and Off. If set to A, the projector will only respond if the keypad
using the REMOTE jack is set for protocol A operation. If set to B, the pro-
jector will only respond if the keypad using the REMOTE jack is set for
protocol B operation. If set to “A or B”, the projector will respond to both
protocol settings for keypads using the REMOTE jack. If set to Off, the
REMOTE jack is disabled.
Communication Setup
Press from the Remote Control Options menu
to set the projector identification number and the
RS-232 serial port baud rate.
Projector
This item contains the projector’s identification number. The projector’s
identification number allows IR remote control of a single projector in a
multi-projector installation. To set the projector identification number,
select item 1 then enter a three digit number from 000 to 999. If there is
only one projector in the installation, 000 is the recommended projector
number. For more information about multi-projector control, refer to
section 3.8, Multi-projector Functions.
2
2 6 UTIL
OPERATION
3.45