Madrigal Imaging MP-9 - Manual (Page 18)

2.4 Mounting The projector should be mounted after the system design has been
established and reverse scan setup (if required) is complete.
Front Screen
➤
Installations
Floor Mount
Mount the projector on a secured table or cart. Position the projector at the
chosen room location with the projector pointing towards the center of the
projection screen. The angle of projection, combined with the tilt angle of
the screen should direct the reflected image towards the center of the audi-
ence. It is recommended that the difference between the projection angle
and the screen tilt angle (within a common reference) be less than 15°.
Refer to Figure 2-9.
Figure 2-9. Floor Mount Installation
You can adjust projection angle and level by adjusting the height of the
projector legs. See Figure 2-10.
Figure 2-10. Leg Adjustment
Ceiling Mount
Mounting the projector to the ceiling requires the use of a projector ceiling
mount fixture. The fixture is shipped from the factory in kit form (with
assembly instructions) for assembly and installation by the dealer/installer.
For more information, contact your dealer or Madrigal.
INSTALLATION & SETUP
2.12