Madrigal Imaging MP-9 - Manual (Page 39)

Figure 2-23. ASR System Example #1
To prepare setup memories for the above system, follow these steps:
Step 1
Select the input using the Source command. Press to select
projector slot 1.
Step 2
Press twice to display the Current Input Parameters status page. Check to
see if ASR is off for the current input. If it is on, press to turn ASR
off for the input. (It is usually easier to prepare setup memories when ASR is
turned off.)
Step 3
At the computer, switch to an application which uses one of the graphics
adapter operating modes. Select an unused Recall memory as the current
setup memory. For example, to make Recall memory 01 the current setup
memory, press
. Make display adjustments as required. The display
settings for the current graphics mode will be stored in the Recall memory.
Repeat this step for the remaining graphics adapter operating modes, storing
adjustments for them in Recall memories 02, 03 and 04. It is recommended
that the two extreme frequencies be set up first.
Step 4
Press to make Input memory 01 the current setup memory then
press to display the Clear Setup dialog box. Move the cursor to
“Do It” then press to clear the display and frequency settings of the
input. Now Input memory 01 will not be used during an ASR search.
Step 5
Press to lock Input memory 01 to prevent display or frequency
changes to the Input memory.
3 1 UTIL
ENTER
5 1 UTIL
1 0 SOURCE
1 0 RECALL
4 1 UTIL
1 0 SOURCE
Source with multiple
scan rates / operating
modes.
MODE
1
2
3
4 Text
Graphics
Graphics
Graphics
31.5 kHz
35.6 kHz
64.0 kHz
110.0 kHz
01
02
03
04
Input 01
TYPE FREQ. (H) RECALL#
INSTALLATION & SETUP
2.33