Madrigal Imaging MP-9 - Manual (Page 86)

Language (English, French, German, Spanish, Italian)
Menus and text can be displayed in English, French, German, Spanish or
Italian. To change the language, select the Language item in the menu until
the desired language is shown.
Programmable Events (On/Off)
This item allows you to enable or disable the Programmable Events feature.
If Programmable Events is set to On, the events flagged as “ENABLED”
in the Programmable Events feature box (
) are automatically
executed at the dates and times specified. If Programmable Events is set to
Off, programmable event execution is disabled.
(For information about event programming, refer to the Clock/Events entry
in this subsection.)
Remote Control
➤
Options
Remote Control Options allow you to modify the projector’s communication
settings for operation with remote keypads and control devices.
To select the Remote Control Options menu,
press
from the Utilities menu. Two selection
items are displayed: Keypad Options and
Communication Setup.
Keypad Options
Press from the Remote Control Options
menu to display the Keypad Options menu.
Use the menu to select the keypad protocol
type the projector will respond.
IR Sensor
This setting determines how the projector
responds to IR remote keypads aimed at
the projector’s built-in IR sensor. Select
the IR Sensor menu item to change the
current setting. Four settings are available:
A or B, A, B, and Off. If set to A, the
projector will only respond if the keypad is set for protocol A operation.
If set to B, the projector will only respond if the keypad is set for protocol
B operation. If set to “A or B”, the projector will respond to both protocol
settings. If set to Off, the projector will not respond to IR keypad commands.
The reason for having two protocols available is to allow two projectors in
the same room to be independently controlled by separate remote keypads.
See Figure 3-8 on the next page.
1
1 6 UTIL
6
2 7 UTIL
6 5 UTIL
5 5 UTIL
OPERATION
3.44