Madrigal Imaging MP-9 - Manual (Page 82)

Channel List
➤
The Channel List utility allows you to display and program the projector’s
Channel List. The Channel List is a user-programmable list of sources and
projector setups. Sources added to the list can be quickly switched to and
displayed by entering their assigned two-digit channel number. Channels
may also be selected using the keypad’s up and down arrow keys. Channel
selection is described in section 3.3, Source Selection.
To display and/or program the Channel List, press from the Utilities
menu. The initial display shows the first ten channels in the list. Up to
99 channels can be displayed. For each channel a name, input number
(switcher and slot number), Recall memory number, and up/down list may
be programmed.
Program a channel as follows:
When the Channel List is
first displayed, the cursor is
positioned in the channel
number column. While in
the channel number column,
press
or to highlight
the channel you want.
Alternatively, you can highlight
the channel you want by
entering the channel number
on the keypad. Entering the
channel number also allows
you to select/display/edit
channels beyond the first ten.
Next, press to move the cursor to the Name field. While
in the Name column, and change the character at the
cursor position and move the position of the cursor. Once
a source name has been entered, move the cursor to the Input
field by pressing
or by using . Edit the Input, Recall,
and Up/Down (U/D) fields. See below for field definitions.
To exit the channel list, press
or .
Note: When the cursor is positioned on a edit field, the field may
be cleared by pressing
.
NOTE: If a channel is selected and ASR is on for the same input, and the
incoming frequency does not match the selected setup memories frequency,
it may cause the following: ASR may be triggered, the setup memory may
change and the channel number may be changed to reflect the new memory.
Example: If Channel 4 shows input (1,3) and no recall number and input
(1,3) switcher 1 slot 3 is selected and recall memory 55 is currently selected
then the Source Message box will show that Channel 4 is selected unless
there is another channel with input (1,3) and recall 55.
.
.
C
B
A
space
9
8
7
.
.
EXIT RECALL
ENTER
2
OPERATION
3.40