Minolta CF3102 - Manual (Page 20)

Precautions 2
CF2002/CF3102 2-7
2.2 Installation Requirements
Power Source
The power source requirements are as follows.
● Voltage fluctuation: Maximum 230 V ±10%
● Frequency fluctuation: Maximum ±0.3%
❍ Use a power source with as little voltage or frequency fluctuations as
possible.
Installation Site
To ensure utmost safety and prevent possible malfunctions, install the
copier in a location that meets the following requirements.
-
A location away from curtains, etc. that may catch fire and burn easily
-
A location that is not exposed to water or other liquids
-
A location free from direct sunlight
-
A location out of the direct airflow of an air conditioner or heater, and
not exposed to extremely high or low temperatures
-
A well-ventilated location
-
A location that is not exposed to high humidity
-
A location that is not extremely dusty
-
A location not subjected to undue vibrations
-
A stable and level location
-
A location where ammonia or other organic gases are not generated
-
A location that does not put the operator in the direct airflow of exhaust
from the copier
-
A location that is not near any kind of heating devices
CF2002.book Page 7 Friday, June 13, 2003 9:29 AM