Motorola i700plus User Manual
Page 58
58
www.mot.com/iDEN
Desktop Dual-Pocket Charger
The NTN1690 Desktop Dual-Pocket Charger charges Motorola authorized
batteries, as listed on Page 55, for the i700plus phone.
NOTE: The Desktop Dual-Pocket Charger should only be powered by the
included Rapid Power Supply. The Charger will flash both LEDs red if
the Standard Travel Charger is attached.
Figure 3.
Desktop Dual-Pocket Charger
Charging a battery:
1.
Insert the power supply’s DC jack plug into the DC jack receptacle on the
back of the Charger. Use only with the Motorola rapid charger included
with your Desktop Charger package.
2.
Plug the power supply end of the power-supply cord into any standard AC
outlet. The Charger performs a quick power-up
self-test during which both LED indicators flash green once to indicate a
successful power-up.
3.
Attach a battery to your i700plus phone. Place the i700plus phone onto the
pin connector located in the charger’s front pocket.
Data Operation
1.
Insert the round end of the iDEN Data Cable (NKN6522) into the data
cable receptacle located on the back of the charger, with the Motorola logo
facing upwards.
2.
Connect the opposite end of the data cable to the PC.
NOTE: Charging times may vary when performing data operations.
Data cable receptacle
(DC jack)
Rear pocket
Front pocket
Pin connector
LED indicators
Power supply cord receptacle