Manitowoc Ice CM MODEL STH003 - Manual (Page 29)

29
Step 7 Take all removed components to a sink for
cleaning. Use 1/2 of the cleaner/water mixture to clean
all components. The cleaner solution will foam when it
contacts lime scale and mineral deposits; once the
foaming stops, use a soft-bristle nylon brush, sponge
or cloth (NOT a wire brush) to carefully clean the parts.
Disassemble the spray bar, remove nozzles and
inserts and soak for 5 minutes. For heavily scaled
parts, soak in solution for 15 – 20 minutes. Rinse all
components with clean water.
Step 8 While components are soaking, use the other
1/2 of the cleaner/water solution and a nylon brush or
cloth to clean inside of ice bin. Clean inside of door,
door gasket, bin, top of evaporator and evaporator
bucket. Rinse all areas thoroughly with clean water.
Step 9 Mix 1 oz (2 tablespoons) sanitizer with 2 gal of
warm water.
Step 10 Use 1/2 of the sanitizer/water mixture to
sanitize all removed components. Use a cloth or
sponge to liberally apply the solution to all surfaces of
the removed parts or soak the removed parts in the
sanitizer/solution. Rinsing is not required.
Step 11 Use the other 1/2 of the sanitizer/water
solution and a sponge or cloth to sanitize the inside of
ice bin. Sanitize inside of door, door gasket, bin, top of
evaporator and evaporator bucket. Rinsing is not
required.
Step 12 Replace all removed components.
Step 13 Prepare 1/2 oz (1 tablespoon) of undiluted
Manitowoc Sanitizer.
Step 14 Reapply power to the ice machine, then press
the Clean switch.