Manitowoc Ice CM MODEL STH003 - Manual (Page 27)

27
Step 2 Press the clean switch. The ice machine will
initiate a 2 minute harvest to remove any remaining ice
from the evaporator.
Step 3 Remove all ice from the bin.
Step 4 Wait 3 minutes until the Clean light flashes,
then add the prepared Manitowoc Cleaner by lifting the
water shutters and pouring directly into the spray area.
Step 5 The ice machine will automatically time out a
ten minute cleaning cycle, followed by eight rinse
cycles, and stop. The Clean light will turn off to indicate
the clean cycle is complete. This entire cycle lasts
approximately 30 minutes.
Step 6 Prepare 1/2 oz (1 tablespoon) of undiluted
Manitowoc Ice Machine Sanitizer (part number 94-
0565-3 only) in a container that will fit into the same
area.
Step 7 Press the Clean switch. Wait 3 minutes until the
Clean light flashes, then add the prepared Manitowoc
Sanitizer by lifting the water shutters and pouring
directly into the spray area. The ice machine will
automatically time out a ten minute sanitizing cycle,
followed by eight rinse cycles, and stop. The Clean
light will turn off to indicate the sanitizing cycle is
complete. This entire cycle lasts approximately 30
minutes.
NOTE: The ice machine will automatically continue
from the previous point before the clean cycle was
initiated.
A. If the ice machine was in the ice making
cycle, the control board will start ice making
again.
B. If the ice machine was in the off cycle, the
control board will turn off.