Macsense Connectivity MPC-200 User Manual

Page 37

where [optional switches] are:

-h Get help screen

-il INTERRUPT LINE

Note: Use DECIMAL numbers for INTERRUPT LINE The default interrupt is 9

(when run with no switches).

Example:

This example shows the ADJIRQ command without switches. It has assigned IRQ 9

to the CardBus bridge.

C:\> ADJIRQ

+--------------------------------------------------------------------------------------+

Build Date: Sep 25 1998

Routing interrupt 9 to CardBus bridge

Found TI1130 bridge

Example:

This example shows the ADJIRQ command with interrupt number switch used. It

has assigned IRQ 10 to the CardBus bridge.

C:\> ADJIRQ -il 10

+--------------------------------------------------------------------------------------+

Build Date: Sep 25 1998

Routing interrupt 10 to CardBus bridge

Found TI1130 bridge

2. STARTER.EXE

PCI-to-CardBus bridges and CardBus devices behind the bridges, need to be con-
figured by software during power-up of a system. Typically configuration code in the
systems BIOS will perform this function. These utilities are written to be used on
systems with BIOS that doesn't have PCB support yet, so the PCB's and this

CardBus device downstream of the PCB's can be configured.

PCI to CardBus

Appendix B Error Messages of Enabler Programs