Macsense Connectivity MPC-200 - Manual (Page 25)

Chapter 6 Driver Installation For Windows NT 4.0
The installation procedure assumes the network component has been installed on your
computer. To check whether the network component has been installed, double click the
Network icon in Control Panel. If not installed, refer to the Windows NT 4.0 installation
guide to install the component.
While installing the network component, Windows NT 4.0 will ask you to install the
driver of network adapter. The driver installation procedure is similar to the following one.
Driver Installation
Follow the steps below to install the driver.
1. Insert the Macsense Fast Ethernet CardBus Card into an open CardBus slot on
your notebook computer. Login to NT 4.0 as the administrator.
2. Double click Network icon in Control Panel, and select Adapters tab, the window
below will show.
23
Driver Installation For Windows NT 4.0