Macsense Connectivity MPC-200 - Manual (Page 24)

NDIS 3 Driver Parameters for Windows NT 3.51
Connection_Type: Specify the attached medium type. Default is AutoSense.
I/O_Port: Specify the starting address of I/O port range. The default
value is D000.
Memory_Base_Address: Specify the starting address of the Shared Memory range.
The default value is D0000.
Interrupt_Number: Specify the IRQ number. The default value is IRQ 11.
Socket_Number: Specify the socket number in which an mpc-200 is inserted.
The default value is
Auto detect .
Interrupt_Style: Specify the CardBus bridge interrupt routing strategy.
Default is
PCI-IRQ-Routed .
Interrupt_Routing: Specify which interrupt pin is used while the CardBus
bridge is using
PCI-IRQ-Routed . Default is INT A .
Store_And_Forward: Setting this parameter causes the NIC to disable the trans-
mit data pipeline operation. Default is
ON .
It is extremely important to assign correct values for the Interrupt_Number (IRQ value)
and Interrupt_Style parameters. If the system uses the PCI-IRQ-Routed interrupt style, it
is also important to assign the correct PCI Interrupt_Routing value (i.e. INT A or INT B.)
If in doubt about the values to assign to these parameters, you are advised to execute
the STARTER.EXE enabling program in a native MS-DOS system first. STARTER.EXE
displays the IRQ value used, as well as the system's interrupt style. For the Windows NT
driver, you should assign the same values to the above parameters as those displayed by
STARTER.
Driver
22
Chapter 6 Driver INstallation for Windows NT 4.0