Macsense Connectivity MPC-200 - Manual (Page 33)

Appendix A Troubleshooting for Windows Environment And PCI
CardBus Bridge Utilities
These guidelines give you tips to deal with some problems on using Macsense Fast
Ethernet CardBus Card. If the problems remain unsolved, please contact your dealer for
assistance.
Windows 95 OSR2
1. Ejecting the Macsense Fast Ethernet CardBus Card from the CardBus socket will
hang or reboot the computer.
Solution: To prevent this phenomenon, stop the card by using the PC Card tool in the
Control Panel or the PC Card icon on the taskbar before you remove the
card.
2. Fast Ethernet CardBus Card can not be detected when reinserted. It is caused by
certain unstable CardBus status lines for the time when the card is removed and
reinserted. The Windows 95 drivers may read an incorrect status during this period
of signal instability, and fail to detect the correct status of the card.
Solution : The card can be detected by clicking Refresh in Device Manager.
3. The card in the docking station cannot be recognized or configured, or cannot func-
tion. This problem occurs in some docking stations and prevents IRQ available to
the PCI bus ram being assigned to CardBus devices in the docking station.
Solution: This is a hardware problem. Contact your docking station manufacturer for
a remedy.
4. Inserting the card into the docking station causes the system to reboot. This symp-
tom has been observed with certain docking stations.
Solution: Contact your computer manufacturer for a possible remedy.
33
Troubleshooting for Windows Environment