Matsushita CF-Y5LWVYZ 1 2 User Manual

Page 75

0-0.5

Heat radiation grease(G-751)
Spreading

(Heat radiation plate for CPU)

6-8

9-11

3-5

13-15

Heat radiation grease(G-751)
Spreading

(Heat radiation board)

Grease spreading
on the other side

HDD Seat putting

HDD seat putting:
Flaking off paper
three places

Heat radiation plate installation for CPU

Heat radiation board
installation

Thing without concave part
range running aground of
top case,and thing without
waving

To the hole part of
a top case

To the range of the heat
radiation board of the
steps dropping part

Thing without concave part range
running aground of top case,and thing
without waving

The flaking off paper of a
two sided tape of the top
case preparation is put
and peel HDD seat is put.

Peel off slowly when you peel off
the flaking off paper.
(Transformation and measures)

Disk cover fixation
seat putting

Grease spreading on the
other side with treatment device

K/B Heat radiation seat putting

Thing without concave part range running
aground of concave part and disk angle
of top case, and thing without waving

Heat radiation grease spreading position

Disk side cover fixation seat putting position

Cable confirms the slit part and
the going thing is confirmed

The externals overplus to
which Cable does not go
out of the Top Case side is
processed under Board

Processing of Antenna Cable

Draws under the side of Board
after tightening of the Screw and
pushes into the inside too much

Processing of Antenna Cable

The tightening order A T
The following are pretermission

Disk Angle
installation

The cable is along bossing
outer and processed.
Do not go out of the above
cabi side.

When there is BT

DXHM0056ZA

Cable is tightened and so as
not to bite, the putting out
Screw is tightened on the out-
side among Board and boss-
es

DXQT2+E6FNL
DXQT2+F3FNL
DXQT2+E10FNL
DRQT2+E8FKL
DXHM0056ZA

Engages with Board's con-
cave part Top Case Rib

9.3.6.11. Top Case side screw tightening

9.3.6.12. Installation of K/B Heat Spreader