Matsushita CF-Y5LWVYZ 1 2 - Manual (Page 37)

37
9.3.2.4. Putting LCD Magnet
Pressurize it from the Front Case side (painting side) when you
pressurize a two sided tape
Affixes between ribs
Paste side
Refer to A chart.
The LCD Magnet is
affixed to the dotted
line part.(Affix on the
plate side)
LCD Magnet
Use the treatment device
when you affix the LCD
magnet
Division attention for XGA
(There is marking)
Safety Work
LCD
The both sides tape flak-
ing off paper is peeled off,
and affixes to Front Case
The both sides tape flak-
ing off paper is peeled
off, and affixes to Front
Case
The both sides tape flaking
off paper is peeled off, and
affixes to Front Case
When inserting in the
Front Case, it is noted
not to roll the cushion
When inserting in the
Front Case, it is noted
not to roll the cushion
Fit to inside surface.
(Attention)
-The LCD Front is installed in the receiving stand, and works.
9.3.2.5. Putting LCD Cushion / Assembly of the Inverter
LCD
LCD
0 1mm
2-5mm
0-3mm
Connection
Pink
Inverter Board
Safety important parts
PET Tape
Standard of match affixation
of connector externals
(0 1mm)
After affixing
the PET Tape
Affixes in a connector
externals putting to-
gether.(wrapping)
0 1mm
LCD Cushions
LCD Cushion 2
LCD Cushion 2
LCD Cushion 1
LCD Cushion 3
LCD Cushions
Paste side
Paste side
Paste side
Rib
Rib
Paste side
Paste side
Paste side
There is no space.
There is a space.
Affixes to the length wall side.
Do not bend, do not twist, and
do not add the impact when
you handle Inverter.
Safety Work
Safety Work
Safety Work
(Attention)
-The LCD Front is installed in the receiving stand, and works.