Matsushita CF-Y5LWVYZ 1 2 User Manual
Page 58
58
Speaker Ring affixation
Speaker Ring affixation
Blue
Cable drawing out side
Cable drawing
out side
The speaker which has
been prepared is installed
The speaker which has
been prepared is installed
Speaker Ring must not
hang on the positioning
rib side of the speaker
The rib of the speaker is
set to the concave Top
Case part
< Speaker installation position-Red >
Soldering temperature
: 300-350 degrees
Soldering time : 3 seconds
Speaker Cable
Blue
< Speaker installation position-Blue >
The rib of SP is set to the con-
cave Top Case part
Blue
Red
Red
Red
Pin No.1(Red)
Safety work
The height of the solder
height shall not be from
a magnet heaven side.
Rib side
affixation position> L type rib side L type rib side Sticks to Cable A red lead fixes with the Line This side of 0 Square hole Boss bese Affixes in boss’s outside di- Pad SW Sheet Solenoid Line Sheet Safety work Line Hold Sheet 8 Processes so that Ca- Top Case’s U type slit This side of a round pin is passed Thing that running aground is not Solenoid A’ssy The part where the axis can be Screw(DXHM0056ZA) Solenoid Spacer Work notes < SCWER tightening torque > Conclusion first time power : 0.16-0.18N m{ 1.6-1.8kgf cm } At the repair : 0.10-0.12N m{ 1.0-1.2kgf cm } 9.3.4.11. Assembly of the Solenoid 9.3.4.12. Assembly of the Speaker
and affixes
Sheet (Solenoid) in the state
in this side
a round pin
is passed
ameter application and Top
Case’s corner hole is con-
cealed
affixation
affixation
affixation
ble should not stretch
part is passed
on boss heaven side along boss
side
installation
tied up is fixed into U type pro-
jection part of metal fittings
affixation