MITSUBISHI ELECTRIC WS-55711 - Manual (Page 67)

66 67
Figure 1. Programming the remote to control your cable
box.
Figure 3. Programming the remote to control your VCR.
Figure 2. Programming the remote to control your
satellite receiver.
Programming the Remote Control to Control Non-NetCommand™
AV Products
To Program the Remote to Control
Other Brands of Audio and Video
Products:
(Figures 1-5)
1. Move the slide switch at the top of the
remote to the product you want to control.
2. Press and hold the POWER button on the
remote control.
3. Enter the first three digit code listed for
your equipment, and then release the POWER
button on the remote control.
4. Point the remote control at the equipment
and press the POWER button. If the equipment
responds, the remote control is properly
programmed to operate the equipment. If the
equipment does not respond, repeat steps 2-4
with the next three digit code listed in step 3 for
your equipment.
IMPORTANT
If you cannot turn the cable box ON
by pressing POWER, try pressing
CHANNEL or the number buttons.