MITSUBISHI ELECTRIC WS-55711 - Manual (Page 66)

66 67
Figure 1. Programming the TV remote to control your
NetCommand™ A/V devices.
NetCommand™ CODE to ENTER
TV Control and NetCommand™
935
Devices:
Programming the Remote Control to Control NetCommand™ A/V
Products
To Program the Remote to Control
NetCommand™ A/V Products:
(See NetCommand Supported Devices, for the list
of A/V products supported by the NetCommand™
System.)
1. Move the slide switch at the top of the
remote to the TV layer.
2. Press and hold the POWER button on the
remote control.
3. Enter the three digit code of 935, and then
release the POWER button on the remote
control.
4. The remote control is now programmed to
send NetCommand™ signals to the TV so
the TV can control the IEEE 1394 devices and
selected older NetCommand™ supported IR
devices. See the NetCommand™ guide for
details.