MITSUBISHI ELECTRIC WS-55711 - Manual (Page 28)

28 29
NetCommand™ Setup
When you first power On your new Mitsubishi TV, the initial setup screens will appear. You will need to
navigate through these screens and properly set up the equipment connected to the TV in order to use
NetCommand™.
NetCommand™ supports the automatic switching of audio and video inputs using only the TV Remote
Control.
Language Screen
Figure 1
The Language screen is the initial menu displayed
the first time the TV is turned On. You will need to
select the language you would like to use. When
you change your selection from English to Spanish,
all screens automatically change to Spanish. To
change Language later, go to Setup in the Main
Menu.
Figure 1. Setup-Language screen.
Information Screen
Figure 2
The Information Screen describes how to proceed with
or cancel the initial NetCommand™ Setup.
NetCommand™ Setup is initialized automatically the first
time you power On your new TV. If, for any reason, your
NetCommand™ Setup is cancelled before completing,
follow the steps below to start NetCommand™ setup
later.
1. Display the TV Main menu.
2. Select the Setup menu.
3. Select the Edit NetCommand™ option in the Setup
menu.
4. Select Initial on the Edit NetCommand™ menu
Result: The AV Receiver screen displays.
Figure 2. NetCommand™ Info screen.
IMPORTANT
You may use your TV without setting up NetCommand™. You may also
setup NetCommand™ at a later time by choosing Setup from the Main
menu, then select Edit NetCommand™.