Connecting to the network, Pre-installation requirements, Mounting the switch – Milan Technology MIL-S3580 User Manual
Page 11
11
3. Connecting to the Network
This section provides the installation procedure and instructions for assigning an IP
address.
Pre-Installation Requirements
Before you start hardware installation, make sure you have the items listed below.
z PCs with 10/100Mbps Ethernet NICs or 100Mbps Fiber NICs: Your PC
must have a standard Ethernet interface to connect to the switch.
z UTP cable with RJ-45 connectors or Fiber cable connectors: Check if the
cable and connectors work properly.
z A power outlet with range 100 to 240VAC at 50 to 60 Hz: Make sure that
the power switch is accessible and cables can be connected easily.
z Dedicated power supply: Use dedicated power circuits or power
conditioners to supply reliable electrical power to the network devices.
z A dry cool place: Keep the switch away from moisture. Avoid direct sunlight,
heat source, and high amount of electromagnetic interference around.
z Mounting tools: If you intend to mount the switch on a rack, make sure you
have all the tools, mounting brackets, screws etc.
C
C
C
A
A
A
U
U
U
T
T
T
I
I
I
O
O
O
N
N
N
:
:
:
c Cabling must be away from sources of electrical noise such as radio, computers,
transmitters, broadband amplifiers, power lines and keep away from TVs,
hair dryers, and microwave.
c Airflow around the switch and through its vents on the rear cannot be restricted.
Mounting the Switch
The MIL-S3580 is suitable for use in an office environment where it can be
rack-mounted in standard EIA 19-inch racks or as a standalone device.