beautypg.com

User instructions, Equipment attachment limitations – Motorola DSR315 User Manual

Page 8

background image

vi

Regulatory

User Instructions

If this equipment does cause interference to radio or television reception, which can be determined by
turning the equipment off and then on, the user is encouraged to try to correct the interference by one or
more of the following measures:

-

Reorient or relocate the receiving antenna.

-

Increase the distance between the equipment and receiver.

-

Connect the equipment into a different outlet so that the equipment and receiver are on

different branch circuits.

-

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by Motorola could void the user’s right to operate the
equipment and/or the equipment warranty.

Equipment Attachment Limitations

Note: This product was FCC approved under test conditions that included the use of shielded I/O cables
and connectors between system components. To comply with FCC regulations, the user must use shielded
cables and connectors and install them properly.

CP-01, Part 1, Section 10.1 .

"NOTICE: The Canadian Department of Communications label

identifies certified equipment. This certification means that the equipment meets certain
telecommunications network protective, operational and safety requirements. The Department does not
guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities
of the local telecommunications company. The equipment must also be installed using an acceptable
method of connection. In some cases, the company’s inside wiring associated with a single line individual
service may be extended by means of a certified connector assembly (telephone extension cord). The
customer should be aware that compliance with the above conditions may not prevent degradation of
service in some situations.

Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated
by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions,
may give the telecommunication company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.

CAUTION: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.

NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an
indication of the maximum number of terminals allowed to be connected to a telephone interface. The
termination on an interface may consist of any combination of devices subject only to the requirement that
the sum of the Ringer Equivalence Numbers of all the devices does not exceed 5.

The standard connecting arrangement (telephone jack type) for this equipment is CA11A.

The Ringer Equivalence Number (REN) of this device is 0.3.