Programming the master power feature – Motorola DSR315 User Manual
Page 17
Using Your Remote
DSR315 User Guide
5
If Your Four-Digit Code is not in the Tables (Scanning)
If you try to program your remote control using the four-digit codes, and the
remote control does not work correctly, you may be able to find a code that works
by using the "scanning" process.
1. Turn on the TV.
2. Press the TV key for at least three seconds—until the LED blinks.
3. The following steps explain how to "scan" through the TV codes stored in
your remote control using the
vkeys. (The LED will not be lit while the
vkeys are depressed.
- While pointing the remote control at your TV, press the
5
key to scan
upward to the next code. (Use the
6
key to return to the previous code.)
- If the transmitted code is the correct one, your TV will turn off,
responding as if its POWER key were pressed.
- If your TV does not respond, depress the
5
key to try the next code.
When your TV turns on or off as a result of the transmitted code, you
will know that you have found the correct code.
- When you have found the correct code (power to your TV is toggled on
or off), press the ENTER key. This will store the manufacturer’s code.
The LED will then flash rapidly several times and turn off.
The DVD, VCR and AUX mode buttons are labeled for convenience. To scan for
a code in these modes you must first program it with a valid code and then follow
the steps for scanning.
NOTE: If your component is not listed in the tables and/or the codes for your
brand are not accepted by the remote, you will need to use the remote originally
manufactured for your unit.
Programming the Master Power Feature
If you wish to control the power on/off function of your receiver and TVwith a
single press of the POWER key on your remote control, you can enable the remote
control’s Master Power feature by following these steps:
• Press the SAT key on the remote control for at least three seconds—until the
light on the key blinks.
• Press the POWER key on the remote. The light will remain on steady. Press the
power key a second time, and the light on the remote will blink on and off
briefly, which indicates that the remote has accepted the Master Power
command.
• If you wish to cancel the Master Power feature, just repeat the steps outlined
above.