Motorola DSR315 - Manual (Page 29)

DSR315 User Guide 17
3
Installation
Connecting the Satellite Dish, Receiver, and TV
Complete the following steps, and make sure that the satellite receiver is not
plugged into a power source before you connect any cables to the receiver:
• Connect the cable from the satellite dish to the satellite terminal on the satellite
receiver's back panel. connect the supplied three-wire (red, yellow, and white)
cable from the TV terminal on the satellite receiver's back panel to TV IN (or
coaxial cable to VHF IN) terminal on your TV.
• On the back panel of the satellite receiver, set the CH3 CH4 switch which is
located just above the TV terminal— to the same channel that you set on your
TV for use with your VCR.
• Turn on the TV and tune it to channel 3 or 4 to match the position of the switch
on the back panel of the satellite receiver.
• Plug the satellite receiver power cord into a standard power outlet. Wait one
minute, and then press the POWER key on the left side of the satellite
receiver's front panel.
Using the Menus
You will be making various adjustments to your receiver using the keys on the
remote control or receiver.
If you use the keys on the remote control to control the menus, there are two ways
to select a menu option:
• Press the 34 keys or the 56 keys to highlight the option you wish to
select. Then press the ENTER key to select it.
• If the options are numbered, simply press the number key for an option.