Acquiring a signal – Motorola DSR315 User Manual
Page 31
Installation
DSR315 User Guide
19
Acquiring a Signal
Complete the following steps to help you acquire a signal:
• Using the number keys on the remote control, tune to the authorization channel
(refer to the information supplied with your system). You should see a banner
with the channel number at the top of the screen.
• Press the OPTIONS key on the remote control. The Options menu will appear.
• From the Options menu, select option 6 (Change System Settings), and the
System Settings menu will appear.
• Select option 3 (Change
Installation Settings),
and on the Installation
Settings menu select
option 1 (Tune in
Satellite Signal).
• Look at the value in the
box labelled Signal. If it
is less than 10, make
sure that all connections
between the satellite
dish LNBF and the
satellite receiver are
correct. If the signal
strength remains below 10, contact your service provider for assistance.
• Using the number keys on the remote control, enter the Provider ID supplied
by your service provider (refer to the information supplied with your system).
You can use the
3
key on the remote control to back up and make corrections.
• If the satellite dish is pointed at the correct satellite, the large field in the center
of the screen will turn green and display the message "Correct signal found". If
you do not see this message within 5 to 10 minutes, the satellite dish may be
pointed at the incorrect satellite. Contact your service provider for assistance.