Motorola DSR315 - Manual (Page 19)

Using Your Remote
DSR315 User Guide 7
• Program the AUX mode with an audio device.
• Press the AUX mode key until it flashes.
• While the AUX mode key is flashing, press and release the TV mode key.
• Press the AUX mode key to complete the programming sequence.
• The remote control will now control the volume of the TV device when in the
AUX mode.
If You Have More Than One Satellite Receiver
If you have more than one receiver, you may want to prevent the remote controls
from affecting the other receivers. To prevent this kind of interference, you must
"pair" each remote control with one receiver. In order to do this, you will have to
assign a new "address" to each pair of remote controls and receivers so that each
pair functions independently of the others.
Using the remote control press the Menu button to bring up the Menu screen on
the receiver monitor (TV).
• Choose Options, choose Change System Settings.
• Choose Installation Settings.
• On the Installation Settings menu, choose Set Remote Control Address. Now
follow the instructions on the Remote Control Address screen.
• If you have multiple receivers, you will have to change the address on each of
them. Choose from following addresses: 0000, 0001, 0002, or 0003.
To program your remote control for each receiver, hold down the SAT key on the
remote control until the light flashes. Once the light begins to flash enter the
desired address.
Replacing the Remote Control Batteries
When the remote control batteries are worn out they must be replaced. Replace
both batteries within two hours of removing the batteries to retain your
programmed codes. The remote control uses two AA batteries. Use only high
quality, non-corrosive batteries designed for use in electronic equipment.
To
replace the batteries:
- Remove the cover by pressing down the back panel indentation and
removing the panel off the remote control.
- Position each battery in the battery compartment so that the flat base (-)
is against the spring and so that the raised contact (+) is against the
terminal. Make sure the batteries are securely seated.
- Replace the cover.