Motorola DSR315 - Manual (Page 36)

3
24
Satellite Audio. Select option 2 and then select Mono, Stereo, Surround or Dolby
Digital (the default is Surround). The Dolby Digital selection will disable other
audio ports.
Installation Settings
Tune in Satellite Signal. This option allows you to see the strength of the signal
your antenna is receiving.
Set Remote Control Address.
This option allows you to
control up to four receivers in a
centralized area, with one or
more remote controls. Each
receiver requires a separate
address. The default address is
0000.
On the front panel of your
receiver press the Menu button
to bring up the Menu screen.
• Choose Options.
• Choose option 6 (Change
System Settings).
• Choose option 3 (Installation Settings).
• On the Installation Settings menu, choose option 2 (Set Remote Control
Address). Now follow the instructions on the Remote Control Address screen.
• If you have four receivers, you will have to change the addresses on three of
them: they will have address of 0000, 0001, 0002, and 0003.
To program your remote control for each receiver, hold down the SAT key on the
remote control until the light flashes. Once the light begins to flash enter the
desired address.