Magellan GLOBAL SATELLITE TELEPHONE - Manual (Page 47)

WorldPhone – Chapter 2. Operation 2.23
M e n u M e n u M e n u Data/printer port setup
Data/printer port setup
General
The DATA port may be set to operate with a PC or, for instance, to
output a Traffic log directly to a printer.
Note! The bit rate setting applies for both PC and printer transfer.
Setup for data communication
• Speed as selected on next page, normally 9600 bps.
Note! The bit rate set between the PC and the WorldPhone must
be higher than the nominal 2400 bps WorldPhone-to-satellite bit
rate to ensure maximum speed transfer.
• No parity *
• 8 data bits *
• 1 stop bit *
* These parameters can only be changed using AT commands,
see
appendix D .
Setup for output to printer
A printer must have serial interface, and is set as follows:
• Speed as selected on next page, i.e. the bit rate specified for the
printer to be connected.
• No parity
• 8 data bits
• 1 stop bit