At & c, At & c0 ç, At & c1 ç – Magellan GLOBAL SATELLITE TELEPHONE User Manual
Page 134: At & d, At & d0 ç, At & d1 ç, At & d2 ç, At & f ç, At & s, At & s0 ç
WorldPhone – Chapter 5. Appendices
D-6
Extended AT commands
AT & C
[n]
ç
determines the Data Carrier Detect (DCD) behaviour:
AT & C0 ç
sets DCD always ON.
Default
AT & C1 ç
sets DCD, only when connected.
AT & D
[n]
ç
selects the Data Terminal Ready (DTR) behaviour:
AT & D0 ç
the WorldPhone ASD ignores
DTR.
AT & D1 ç
the WorldPhone ASD enters
Online Command Mode when DTR goes inactive.
Default
AT & D2 ç
the WorldPhone ASD clears call
when DTR goes inactive.
AT & F ç
resets the WorldPhone ASD to factory default. The
factory default is not saved as with the AT&W command,
so ATZ revokes to last saved values.
AT & S
[n]
ç
selects the Data Set Ready (DSR) behaviour:
Default
AT & S0 ç
sets DSR permanently ON.
AT & S1 ç
sets DSR ON when satellite link
is established.
AT & V ç
displays stored configuration profile.
AT & W ç
saves active configuration profile.
(May be recalled using
AT Z ç
).
AT commands cont’d
Appendix D – AT commands cont’d