Motorola i1000 - Manual (Page 72)

GETTING STARTED 67 i1000
SAFETY AND GENERAL
INFORMATION
RADIO OPERATION
Your portable’s radio component contains a transmitter and a
receiver. When it is ON, it receives, and also transmits, radio
frequency (RF) energy. The radio operates in the frequency range of
806MHz to 866MHz, and employs digital modulation techniques.
When you use your radio, the system handling your call controls the
power level at which your radio transmits. The power level may
typically vary over a range from 0.01 of a watt to 0.6 of a watt.
• Exposure to Radio Frequency Energy
In August 1996 the Federal Communications Commission (FCC) of
the United States with its action in Report and Order FCC 96-326
adopted an updated safety standard for human exposure to radio
frequency electromagnetic energy emitted by FCC regulated
transmitters. Those guidelines are consistent with the safety
standards* previously set by both U.S. and international standards
bodies. The design of your Motorola two-way radio complies with
the FCC guidelines and these standards.
*American National Standards Institute (C95.1 - 1992)
*National Council on Radiation Protection and Measurements
(NCRP-1986)
*International Commission on Non-Ionizing Radiation Protection
(ICNRP- 1986)
To assure optimal radio performance and to ensure that exposure to
RF energy is within the guidelines in the above standards, follow
the operating procedures outlined below.
• Efficient Radio Operation
The following practices will enable your radio to operate at the
lowest power level, consistent with satisfactory call quality.
When placing or receiving a phone call, or using the group or private
call functions with the Group/Private Speaker OFF (muted speaker
icon visible in the display), hold the radio as you would a telephone.
IMPORTANT! Read this information before using your
portable.
Safety and General
i1000 Page 67 Wednesday, June 17, 1998 1:53 PM